Complete tab for this model : - CPU frequency - Temperatures for CPU, Wifi and NVMe disk - NVMe disk throughput

An alternative configuration of the default Ksysguard SystemLoad tab : - 1 pixel per measure instead of 6 - one measure every 5 seconds instead of half second - the yellow receive bar was too bright - the CPUs are stacked I have shared this as I was tired of always hand editing it in new...

Full featured tab for this laptop with AMD E2 APU - CPU Frequencies - FAN speed - APU temperature - Internal disk read/write rates

A battery history plotter, it uses all batteries found at ksysguard launch. It also plots the total power rate, either charging or discharging. NEEDS Ksysguard 5.18 at least, as I added the needed sensors in the summer 2019.

!! This requires lm_sensors to be installed !! Tab with sensor metrics for AMD GPU devices including fan RPM and temperatures. More data unfortunately is currently blocked by limitations in the system monitor itself, hopefully there's going to be improvements to this in a future Plasma release.

Monitor for this laptop : - Exhaust (fan) speed - 11 temperature sensors - Wifi signal strength

Monitor for this special motherboard : 10 temperature sensors!

Complete monitor for this laptop with AMD A8-7410 APU: - CPU global frequency (the cores are not independent) - Fan speed (as of kernel 5.3.11, fan reports 2500rpm when stopped) - Temperature forthe CPU and the GPU - WiFi signal strength - Internal harddrive read/write

- Temperatures: CPU, Motherboard, Chipset, GPU - Voltages: CPU, GPU - Fan Speeds: CPU, Case, GPU I use it for monitoring the heat management, to later adjust in the BIOS the fan speeds while overclocking (games) or rising efficiency to reduce the noise of the machine (work). This Version is...

Full fledged monitor using the dell smm module : - CPU frequency - Fans Speed - Temperature for CPU and Southbridge - Wifi signal strength